GPTORVA programs Automatic or manual functions for filling material torvas of an engine with slowdown

GPTORVA programs Automatic or manual functions for filling material torvas of an engine with slowdown

GPTORVA

          Functions for filling material torvas of an automatic or manual motor with slowing down and anti-crushing in Advance With electric photo-cell, 2 open and closed stops, internal limit switches, automatic-total, NOTE: the internal limit switches are by ammeter, if the automation were in bad condition, the internal limit switches would act if this happens, the machine will have to be corrected (for safety, it would act as anti-crushing) with an optional receiving card and transmitter. 1st. Function: MI1, Gait Pulse. By giving an impulse, the automation will start (instantly) to operate the blow valve (air), it will count a time delay already programmed (Parameter 05.00) and it will start to operate the filling motor to the torva with an acceleration ramp , the ramp time is programmed (parameter 01.09). 2nd. Function: MI2, Photo-cell = (Sensor) will detect the material, note: in this function we can place both a NO / NO Sensor - NPN or PNP, and NO / NA –PNP or NPN. To decipher the Sensor and say what type of Sensor we have (parameter 05.05). While the photocell is acting, no function will act except the stop. 3rd.Function: MI3 and MI4, STOP Here we will find two types of stop, total stop or stop, as long as the automation is in operation when pressing and leaving the pulse active, MI3 or MI4 the automation will stop immediately or stop. MI4 is an open contact when this contact closes it will make a stop (it is used for the digital keypad, or accessories etc.), MI3 this contact is closed when it opens it will make a stop (it is used for pneumatic bands, infrared band or radio active) note: if you refuse the bands, you will have to make a 24v bridge to MI3. This function prevails over all functions. Note and Warnings on Electronic Equipment: Inputs MI5, MI6, AVI, ACI, AFM, are not active in this Software. If, for any reason, any of these aforementioned entries is read, it may be for various reasons internal to the program, since most of the possible functions are explained. If any function not written or explained in this manual is needed, contact your supplier or distributor of this equipment. Important Note: Never contact the factory of the product as it has nothing to do with the software (Program) or hardware (Electronic Device) functions, if this happens they can cause great damage to Humans, machines and electronics. IN MIND THIS PARAGRAPH.